HP Deskjet Plus 4155 Wireless Setup

Carry out anyone of the following procedures to perform the wireless setup on the 123.hp.com/dj4155 printer.

Procedure 1 – Push Button Configuration

Hold the Wireless button on the HP Deskjet Plus 4155 printer’s control panel.

Release this button after three seconds.

Press the WPS button on the front panel of your wireless router.

Check if the Wireless LED on the printer stays blue.

This indicates that the wireless connection has been established successfully.

Procedure 2 – PIN

Hold the Wireless and Information buttons at the same time on the HP printer’s control panel.

Release these buttons after five seconds.

The printer prints a page that contains a PIN code.

Note down the PIN code.

Launch the router’s web interface on your computer and enter the noted PIN code in the WPS section.

After two minutes, check if the wireless LED turns blue.

Comments

Post a Comment

Popular posts from this blog

HP Smart Tank 515 Wireless Setup

 Check to ensure that your HP Smart Tank 515 printer’s hardware setup is completed and ready for the wireless setup. Gather your wireless network’s credentials, such as SSID and password. Ensure that your computer (that you're using) is connected to the same network to which you’re about to connect the printer.  Check if your printer is in network setup mode. If not, restore the network settings of your printer to default to enable the network setup mode. To do so, follow the instructions below. Make sure that your HP Smart Tank printer is turned on. Locate the Wi-Fi and Cancel buttons on your printer’s control panel. Now, hold down both the buttons at the same time. Release the buttons after five seconds. Now, your printer’s network settings will be restored. *Note: You can also use your printer’s EWS page to restore its network settings. Download and run the HP Smart Tank 515 printer software on your computer. When prompted, select the Wi-Fi Connection option and follow the ...
Read more

BROTHER MFC-T4500DW SETUP

 Quick instructions to set up the Brother MFC-T4500DW multi-function color printer Open your Brother printer's product box. You can find the Brother MFC-T4500DW printer, a set of ink bottles, a quick setup guide, a product safety guide, a power cord, an installation disc, USB interface cable, and telephone line cord. Now, take all the components and the printer out of the box. Unpack your printer completely by removing the packing tapes or materials surrounding or present inside & outside the printer. Place the Brother printer on a clean surface area.  Now, remove the printer's paper tray. Based on the paper type that you're loading, align the paper width guides correctly. Load a stack of paper in the tray and place the tray back into the printer. Connect your Brother printer to an electrical outlet and turn it on. Once the printer becomes stable, set the basic printer preferences by following the instructions displayed on the printer screen. After setting them, open th...
Read more

Xerox Versalink C7025 Setup

 XEROX VERSALINK C7025 UNBOXING SETUP Initially, take the Xerox printer out of the box and unpack it completely. Place the unpacked printer on a clean surface. Now, get the toner cartridges provided along with the printer box. Shake the cartridges before unpacking them. Now, open your Xerox printer’s front door. Install the unpacked toner cartridges one by one into their slots and close the front door. Pull out your printer’s front tray. Align the width guides and load paper in the tray. After loading the paper, adjust the width guides correctly and push the tray towards the printer. If necessary, install the optional components into the printer. Now, connect your printer to an electrical outlet and turn it on. Next, you need to set the initial settings of the printer. Perform the initial setup by following the on-screen instructions. Once it is done, begin the printer software installation on your computer. Finally, perform a test print operation to check whether the Xerox VersaL...
Read more